![]() I have read of a couple other people having this issue but have failed to find a solution. The usb connection on the fc is not loose, dislodged or damaged in any way. I am unable to reflash new firmware in dfu mode either. When I do that I hear the “usb disconnected” tone followed by the “usb connected” tone. As soon as I hit the connect button I get a “no configuration received within 10 seconds, communication failed” message that turns into a “failed to close serial port” message. When I plug the fc into the computer I hear the “usb device connected” tone and if I don’t touch inav I never hear it disconnect. When I run the impulse rc tool it gives me an error saying multiple devices detected or something along those lines. I have tried multiple different cables, two different PCs, and ran the impulse rc driver fixer. When I configured gps, and flashed a model on my qx7 then copy and pasted a modes set up in the cli I can no longer connect to inav. (Following the steps from a document in the inav fb group). Whenever I put them into bootloader mode, either via button push, or BL command in BetaFlight, windows comes back with ' USB DEVICE NOT RECOGNIZED '. ![]() I spent a few hours setting up my matek f411-wing fc on inav and connected with no issues. They connect perfectly to BetaFlight, and give live orientation data, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |